DIY Ski Rack for Garage Ideas

May 31st

How to build ski rack for garage can be done by yourself if you are creative enough. I am referring to a rack design where you just slide the skis in. You can have them hang by the ski shovels. This is a thing for sure as wooden rack that very affordable. Do yourself ideas to make the ski rack holds just about as many pair of skis as you can come up with. Here are things that you should have to prepare and do for better values.

Unique Ski Racks For Garage

Finished ski rack in my garage just like what you can see on the image gallery shows a good design. Well, you could just easily continue the rack down the wall’s length to hold as many skis wanted. These are tools that will have to prepare like 3/4″ wood bit, 1/2″ electric drill, power saw (recip, or table saw or circular), Phillips insert bit, screw gun or battery drill, Magic Marker and T-square. You will also need materials like Two 8″ x 6″ – 90° brackets for the ends and a piece of lumber in 2″ x 8″ x however long you want the rack along with 1 1/4″ and 2″ wood screws.

12 Photos Gallery of: DIY Ski Rack for Garage Ideas

Image of: Unique Ski Racks For Garage
Image of: Appealing Ski Racks For Garage
Image of: Best Ski Racks For Garage
Image of: Ski Racks For Garage Gallery
Image of: Ski Racks For Garage DIY
Image of: Ski Racks For Garage Pictures
Image of: Amazing Ski Racks For Garage
Image of: Ski Racks For Garage Image
Image of: Ski Racks For Garage Photo
Image of: Ski Racks For Garage Ideas
Image of: Floor Ski Racks For Garage
Image of: Snow Ski Racks For Garage
 

Mark up the wood by using Magic Marker and the T-square to scribe a line the entire length of the 2″ x 8″ at 1 1/2″ from the edge of wood. Starting from one the wood edge, mark the line of Magic Marker in every 10 1/2″. You can use the mark as the back of a 3/4″ circle. You can start at the Magic Marker line to make parallel scribes from each circle’s side to the opposite of wood edge. Use a dot to mark the center of the circles. Double check the measurements. Drill out the circles by using the 1/2″ electric drill with the 3/4″ wood bit. Just drill through the each circle in the center. Cut out the slots by using sawcut the parallel lines from the edge of wood back to the 3/4″ hole making the slots.

READ  Bicycle Garage Storage Ideas

Attach the brackets of 8″ x 6″ at each of 2″ x 8″end with the 6″ side properly screwed to the wood rack,. Use the 1 14″ wood screws. You can add some brackets that you need so that there is no span longer than 5 feet. Then hang the ski rack by setting and a comfortable height of level the ski rack which then the brackets to be screwed onto the wall with the 2″ wood screws.