How to Building a Garage Workbench
Building a garage workbench – A workbench is an important part of any garage. Build a simple workbench for your garage, providing plenty of work surface while recording minimal space. Spend an afternoon assembly workbench, provided that you have all the necessary equipment and have some knowledge of woodworking.
Determine the height of the building a garage workbench. Mark the height of the wall with a snap line. Check line with a plan and make the necessary adjustments. Install metal bracket on the wall studs. Place the top part of the bracket just below the snap line on the wall. Pre-drill holes for the bolts. Use heavy bolts and a drill to install the brackets. Cut six 22-inch lengths of wood from a 2×4. Place a piece of carved wood on top of each bracket. The butt end of the tree against the wall stud. Attach the wood to the bracket with wood screws.
Measure and cut three pieces of wood from a 2×4, there are approximately 109 inches. Establishes these lengths of wood on the support bracket. Place a piece against the wall, one in the middle and one at the outer edge. Secure them with nails. Place the remaining small lengths of wood at the end of the cross supports. Secure them in place with nails. The last 2×4 to measure 110 inches. Attach this piece on the front of the building a garage workbench by nailing it to the front of the support pieces. Use a saw to cut chipboard, so it is 110 inches long. Cut the table in the middle, so you have two 24×110 cm pieces. Stable chipboard top of each other, and put them on the two by four supports. Particle board seam to supports.building a garage workbench, building a workbench in garage, building garage workbench, building workbench in garage, diy workbench with drawers, how to build a simple workbench in garage, how to build a workbench against a wall, how to build garage workbench, building a workbench for garage